Teat MTM

Latex teat with medium, thin nipple suitable for:

  • in-pouch kangaroos
  • in-pouch wallabies
  • in-pouch koalas.

 

Sleeve fits Wombaroo Feeding Bottle or any bottle with neck diameter of 18-24mm.

Teat Selection

The teat should resemble the mother's in size and shape to ensure mouth comfort, fit and correct tooth eruption. Marsupial teats get longer as the joey grows, so progression to longer teats is important.

Hole Size

There is no hole in the teats, so the carer needs to make a hole to suit the animal being fed. Pierce the tip of the teat with a hot needle to make a hole about 1 mm in diameter, or for large animals, cut a hole with scissors. If the hole is too small, excessive sucking will quickly weaken the tip and the end will blow out. If this is happening then the hole is probably too small for the animal. Make a larger hole. The hole should be large enough for milk to drip out slowly, when the bottle is inverted.

Feeding Technique

Small animals can be fed using a syringe with a teat pulled over the end, to give greater control of milk flow with the plunger. Guidance should be obtained from experienced carers on correct feeding technique for different animals.

Care & Storage

Latex is a natural product. Deterioration can be slowed by storing teats in a dry place away from light. An opaque, airtight container should be used. Immediately after use, teats should be washed in warm soapy water, dried and stored as above. Some carers sterilise by boiling or with infant sterilising solutions.